Faucet is a tool we need to use water in our lives. It makes water use more convenient and simple, and provides great convenience to our daily life. But how do we install Stainless Steel Faucets ?
1. Installation of single hole basin faucet
When buying a single-handle basin faucet, you should pay attention to the diameter of the spout. Most of the water in the market belongs to the hard pipe, so you should pay attention to the height of the upper spout. It is most suitable to go down from the basin to 35 work points. During installation, a special angle valve must be selected, and the angle valve must be fixed to the hot and cold water pipes out of the wall. When you find that there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect it. Remember, you must not use other water pipes to connect, because if the water pressure is high, it will easily fall off and leak water, causing you loss. If the inlet pipe is too long to exceed the outlet pipe, the part can be cut off according to your needs. If the angle is not suitable, you can bend it to the position you need. Remember: Do not bend hard to 90 degrees or more than 90 degrees. When installing the basin to drain, please don't forget to purchase the small connector of the faucet (short-circuit the faucet). Please don't forget to flush the water pipe buried in the wall before you install it.
2. Installation of shower and bathtub faucets (wall hanging)
After you buy a shower, bathtub, or wall-mounted faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 cm. Before installation, you must not forget to flush the water pipe to prevent the water from being too hard and causing damage to the faucet. Concealed shower and bathtub faucets: After purchasing a concealed faucet, the valve core of the faucet is generally pre-buried in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the valve core will not be embedded. Do not remove the plastic protective cover of the valve core easily during pre-embedding, so as to avoid damage to the valve core by cement and other chores during pre-embedding. In addition, you should pay attention to the up and down, left and right directions of the spool when embedding the spool to avoid the wrong spool. When the wall-mounted faucet is pre-embedded in the water inlet pipe, there is a deviation in the size, and the adjustable crutches can be used to adjust the position.
3. Installation of thermostatic faucet
Before installing the thermostatic faucet, please check whether the water pipes are hot on the left and cold on the other. Remember not to install the hot and cold water pipes incorrectly to prevent the faucet from not working properly. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. Don't forget to install the hot and cold water filter when installing the thermostatic faucet.
4. Installation of single hole kitchen faucet
It is required to be stable, because the kitchen faucet is used frequently and is easily loosened when being moved around. Therefore, the lock nut must be tightened. There have been some faucets on the market to fix the screw pipe with enlarged nut. This kind of stabilization effect is very good. If the problem of water removal and lifting can be solved, it will be a popular trend in the future.
The above content is organized and shared by Kitchen Faucets Manufacturers , hoping to help those in need.